Light-cured Rubber Dam liquid 1.2ml

Light-cured RUBBER-DAM liquid

Light-cured RUBBER-DAM liquid is dedicated for: 

• gingiva protection during dental treatments: whitening, etching, microabrasion, sandblasting, endo, etc.
• sealing rubberdam
• other procedures requiring intraoral protection
• to block out undercuts prior to taking impressions

Content of the box:

• Syringe containing 1.2 ml of the preparation + disposable applicators
   

How to use it:

• For gingiva protection during dental treatments:
  Clean and dry gingiva. With the use of appropriate instruments (e.g. buccal and labial retractor) immobilize lips and a tongue in order to avoid contact with the liquid. Remove the syringe lock and install the included disposable applicator. Apply RUBBER-DAM LIQUID along the application area 4-6 mm wide and approximately 1.5-2 mm thick, at the same time overseeing the amount of the preparation being applied (Pic.1). If possible, squeeze RUBBER-DAM LIQUID through interdental space. Cure the preparation for 15 seconds using polymerization lamp (Pic.2). Conduct the curing process evenly in a scanning motion. Then, proceed the dental treatment. After the treatment is completed, lift off polymerized RUBBER-DAM LIQUID using the instrument on the either side and remove.
  
  
   
• In order to seal rubber dam:
  Isolate the working area (tooth, teeth, alveolus) using RUBBER-DAM. In order to seal rubber dam, apply the layer of the liquid on the edge of the gingiva and the rubber dam (Pic.3, Pic.5). Cure the preparation for 15 seconds using a polymerization lamp. Conduct the curing process evenly in a scanning motion (Pic.4, Pic.6). Then, proceed the dental treatment. After the treatment is completed, lift off polymerized RUBBER-DAM LIQUID using the instrument on either side and remove.
  
                                                        without clamps
  
  
                                                           with clamps

       Please note that if you only order rubber dam, we may slightly flatten the product packaging so they would fit into a large letter box thus enabling us to send it by 1st class mail at no extra cost to you.